Tires are actually quite expensive consumables in the use of vehicles. Four tires are worth thousands of yuan. If they are not used properly, it will cause abnormal losses, but it will be a huge blow to the wallet of car owners! In addition to the recent fluctuations in the international tire market, people are worried about the trend of tire prices. We can't control the price of tires, so how to reduce tire wear and prolong the service life of tires to the greatest extent is the knowledge that car owners must master. The driving mode of the car has a lot to do with the tire wear. Good and skilled driving skills can effectively reduce tire wear, prolong tire life and improve driving safety. Jinan where repair Audi is more professional, here are some suggestions to reduce tire wear.

　　壓力應該達到標準。

　　The pressure should be up to standard.

　　根據工廠的規定，司機必須給輪胎充氣。當胎壓低于標準值時，胎肩磨損急劇增加。當輪胎壓力高于標準值時，由于輪胎地面面積減少，單位壓力增大，輪胎胎面磨損增大，在輪胎剛度增大的同時，車輪受動載荷增大，容易產生輪胎爆胎。

　　According to the regulations of the factory, the driver must inflate the tire. When the tire pressure is lower than the standard value, the shoulder wear increases sharply. When the tire pressure is higher than the standard value, because of the decrease of the tire ground area, the increase of unit pressure, the increase of tire tread wear, the increase of the tire stiffness, the increase of the wheel dynamic load, it is easy to produce tire blowout.

　　胎面無裂縫

　　No cracks on tread

　　定期檢查輪胎表面有無裂紋、變形等缺陷。由于行駛磨損，輪胎胎面花紋槽逐漸變淺。如果輪胎是光滑的，就會失去排水、防滑等功能，汽車的性能會大大降低。此外，看似很小的裂縫是高速行駛時輪胎爆裂的隱患。還要注意及時清除槽內的小石子。

　　Check the tire surface regularly for cracks, deformation and other defects. As a result of driving wear, the tread grooves of the tire gradually become shallow. If the tire is smooth, it will lose the functions of water drainage and antiskid, and the performance of the car will be greatly reduced. In addition, the seemingly small crack is the hidden danger of tire burst when driving at high speed. Also pay attention to the timely removal of small stones in the tank.

　　停車平

　　Parking level

　　避免把車停在有大的、尖銳的或尖銳的石頭的路上。不要把車停在石油產品、酸和其他影響橡膠老化的材料附近或與之接觸。司機停車后不應轉動方向盤，否則會加速輪胎磨損。

　　Avoid parking on roads with large, sharp, or sharp stones. Do not park your vehicle near or in contact with petroleum products, acids and other materials that affect rubber aging. The driver should not turn the steering wheel after parking, otherwise it will accelerate tire wear.

　　不要把水灑在爐子上

　　Don't sprinkle water on the stove

　　在夏季長時間駕駛或高速行駛時，輪胎往往會過熱并增加氣壓。此時應停止加熱，嚴禁抽氣降壓或水冷卻，以防止胎面橡膠的異常老化。

　　When driving for a long time or at high speed in summer, the tires tend to overheat and increase the air pressure. At this time, the heating should be stopped, and it is strictly prohibited to pump air and reduce pressure or water cooling to prevent abnormal aging of tread rubber.

　　避免突然剎車

　　Avoid sudden braking

　　啟動時不要用力過大，避免頻繁使用剎車和緊急剎車，以免加速輪胎和地面拖胎磨損;輪流遇到車輛、超車、通過十字路口、狹窄路面、鐵路道口等路段時，應掌握適當?shù)能囁伲⒆⒁饴访?、行人、車輛的制動準備，減少頻繁制動，避免緊急制動，從而減少輪胎磨損;面對不可避免的碎玻璃或其他異物，要減速通過，不要用力剎車，因?yàn)閯x車造成壓力增大，玻璃碎片和異物更容易卡在輪胎里。

　　Do not use too much force when starting, avoid frequent use of brake and emergency brake, so as to avoid accelerated tire and ground tire wear; When encountering vehicles, overtaking, crossing, narrow road, railway crossing and other sections in turn, proper speed shall be mastered, braking preparation of road, pedestrians and vehicles shall be paid attention to, frequent braking shall be reduced, emergency braking shall be avoided, so as to reduce tire wear; In the face of inevitable broken glass or other foreign matters, slow down and don't brake hard, because the brake causes the pressure to increase, and the glass fragments and foreign matters are more likely to get stuck in the tire.

　　選擇一條好路

　　Choose a good road

　　在公路養護施工路段行駛時，應采用低速、低速路面的選擇方法，避免對輪胎產生過大的沖擊，甚至刺傷、劃傷;在凹凸不平的路面上行駛時，應選擇路面以減少輪胎的沖擊，避免對零件和輪胎的損傷;二要減速慢行，避免輪胎撞擊和強烈震動;通過泥濘路段時，應選擇較堅固、不滑的地方通過，以避免輪胎沉陷、空轉原地、酷暑造成輪胎及輪胎側面劃傷、劃傷。

　　When driving on the road maintenance construction section, the selection method of low-speed and low-speed road surface shall be adopted to avoid excessive impact, even stab and scratch on the tire; when driving on the uneven road surface, the road surface shall be selected to reduce the impact of the tire and avoid damage to the parts and tires; secondly, slow down to avoid tire impact and strong vibration; When passing through the muddy road section, it is necessary to choose a stronger and non slippery place to avoid the tire sinking, idling in place and the side scratch and scratch caused by the hot summer.

　　控制速度

　　Control speed

　　車輛轉彎時應根據彎道路況，轉彎半徑，一般宜減速，以免加速慣性和離心力的作用，使輪胎單邊磨損;車輛下坡時，可根據坡度大小、長度及路況，控制適當?shù)能囁?，這樣可以避免或減少緊急制動，減少輪胎磨損;當車輛在途中停車和在車站停車時，應養成安全滑行的習慣。

　　When the vehicle turns, it is generally advisable to slow down according to the road conditions and turning radius of the curve, so as to avoid acceleration of inertia and centrifugal force, resulting in unilateral tire wear; when the vehicle goes down the slope, it can control the appropriate speed according to the size, length and road conditions of the slope, so as to avoid or reduce emergency braking and tire wear; When the vehicle stops on the way and at the station, the habit of safe sliding shall be formed.

　　經常檢查備胎

　　Check the spare wheel frequently

　　在輪胎的保養和使用中，不要忘記更重要的輪胎——備胎。備用輪胎由制造商提供，但經常被車主遺忘，缺乏維護。建議您每三個月定期檢查備用輪胎，必要時進行充氣，以避免在需要時發現它癟了。

　　In tire maintenance and use, do not forget the most important tire - spare tire. The spare tire is provided by the manufacturer, but it is often forgotten by the owner and lacks maintenance. It is recommended that you check the spare tire regularly every three months and inflate it if necessary to avoid finding it flat when necessary.

　　注意耐磨性

　　Pay attention to wear resistance

　　濟南哪里修奧迪比較專業，大多數人都不知道,事實上,輪胎的耐磨程度是一個基本指標,不同于它的大小,重量和速度級別是耐磨指數并不確定輪胎的肩膀,也許是因?yàn)槟湍ブ笖?shù)不喜歡超過其他指標將直接影響安裝,或?qū)Π踩珮?gòu)成直接威脅。但有心的車主不妨上網或通過一些其他途徑了解輪胎的耐磨指數這個指數，應該會為你選擇耐磨性好的輪胎起到參考的作用。

　　Jinan where repair Audi is more professional, most people do not know, in fact, the tire wear is a basic indicator, different from its size, weight and speed level is the shoulder of the tire wear index is uncertain, perhaps because the wear index does not like to exceed other indicators will directly affect the installation, or pose a direct threat to safety. But the car owners who want to know the wear index of the tire online or through some other ways should be able to choose the tire with good wear resistance as a reference.